However, it is also due to this structure that it is very difficult to paint composite decking without it looking untidy and unprofessional. This helps the colour to stay bright and strong for many years. Unlike timber, which simply has a layer of paint on its surface, the colour of composite decking is added during the manufacturing process and runs through the entirety of each deck board. However, whether you should paint your composite decking is probably a better question! Too bad you had to be an early user andĮxperience these problems.The short answer is yes you can. There are plenty of additives that could retard the wood molding andĪpparently they now use them. Some dyes and pigmentsĪre degraded by light so hopefully they now only use those that hold up. I don't know about the initial problem but now it isįaced with PVC which has good light stability. Polyethylene and sawdust would not hold up mainly because of PE beingĭegraded by UV. When if first came out, as a chemist, I was skeptical that a blend of Trex has been around for maybe 20 years nowĪnd had its growing pains but is matured and holding up better. When I considered using a man made product instead of wood, a big factor I suspect you got the early Trex product that did have these problems Looks great without the problems you mentioned. I posted a year and a half ago about getting Trex deck and it still Pain in the rear and never would use Trex again, oh did I already say that? My deck is not shaded so there is no reason that I can think of why the Trex I used looks ugly within a few months after it has been cleaned. Not only do I have to clean it at least twice a year but it has faded from saddle brown to a beige from the cleaning solution recommended by Trex. I have to clean it at least twice a year because it molds and mildews. I used Trex to build a 20' X 16' deck about 8 years old. > You (finally) went to the proper source for information and still > I used Tigerwood and enjoy the beauty every time I step on the deck. > replace it with real hardwood and oil it to keep it looking beautiful. > The only reason I'd use Trex is to avoid painting and staining. > man made product with additives in it so it stays good looking for > matter, not the fact that other sites don't say to paint. > What you did wrong was painting the Trex. >Was this a unique experience? What, if anything, did I do wrong? >Wish I'd left the Trex alone it was an unobtrusive pinkish beige-ish color >But other sites don't specifically say don't use paint. Trex only approves 2 coverage, both stains. Used a lot of time and a lot of expensive paint. >After scrubbing and rinsing the steps and letting them dry, I applied BM acrylic. (Yes, the Trex is several years old, so that wasn't a problem). >Since I was painting the (wood) back porch, thought I'd paint the (Trex) side steps to match. Just check that the paint stripper doesn't affect the Trex by If you get tired of the way that paint looks, take it off with a paint Now, if anyoneĮver asks you if they should paint their Trex decking, you have all theĮxperience needed to answer their question with both confidence andĪuthority, having done that once yourself. Would take latex paint off of Trex without harming the Trex, but test in If you get fed up with it, I expect that any paint stripper Likely get very dirty looking because dirt will become embedded in it Steps normally, and the paint should wear off on it's own. Provide good service on a working surface such as a step. If you painted with a latex paint, then that paint is too soft to Trex is a wood composite material that doesn't need paint to protect itįrom the Sun or from absorbing rain water.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |